OVERVIEW
Welcome
DISA Elektro AG
drill jigs
collet drill chucks
elektrode holder
ext.colling
int.cooling
downloads
contact
agencies
Reglus electrode holder with dia. 10/20mm mm shaft and rotatable
external connection for the flushing liquid

The Reglus Electrode Holder gives 5-fold economy
1. Reduces cleaning work and costly spindle overhauling and thus less idle time of the machine thanks to the external flushing connection)*
2. Increases the machining capacity thanks to the rotating electrode with flushing

3. The symmetrical double cone collets allow an even but strong clamping of the usually thinwalled copper electrode tube (clamping range is dia. 0.3 to 5.0 mm with 11 collets).
4. Also suited for finishing cuts thanks to good roundness accuracy (+/- 0.015 mm typical)
5. Suitable in narrow places thanks to its small diameter (dia. of the front part of the clamping nut is
only 11.5 mm)


*Reglus also offers an electrode
holder with internal flushing facility
(type 350.20.I).

Typ 350.10.E

Reglus electrode holder with dia. 10 mm shaft and rotatable external connection for the flushing liquid

Typ 350.20.E

Reglus electrode holder with dia. 20 mm shaft and rotatable external connection

 sketch:

 

assembling: 

 

Easy to install
1. Select suitable sealing disc(dependent on electrode dia.)
2. Slide sealing disc on electrode
3. Slide support for sealing disc (plainside towards disc) on the electrodeclose to the sealing disc
4. Slide collet on the electrode (towards the sealing disc)
5. Slide the clamping nut over the electrode and the collet
6. Put the electrode about 30 mm inside the body
7. Tighten the clamping nut according to the requirement either by hand or with the included single ended spanner
The assembling of an electrode can be done either on the machine or on a presetting tool.
For copper tube electrodes above an outside dia. of approx. 3 mm neither sealing discs nor sealing disc supports
are required.
The exchange of an electrode is done in the reverse order.

Collets with symmetrical cones for all EH-3 electrode holders:

dia 0.2 - 0.3 mm
dia 0.3 - 0.4 mm
dia 0.4 - 0.7 mm
dia 0.7 - 1.0 mm
dia 1.0 - 1.5 mm
dia 1.5 - 2.0 mm
dia 2.0 - 2.5 mm
dia 2.5 - 3.0 mm
dia 3.0 - 3.5 mm
dia 3.5 - 4.0 mm
dia 4.0 - 4.5 mm
dia 4.5 - 5.0 mm

 

 

 

 

 

Packing list:
A set comprises the following parts:
– 1 electrode holder
– 10 each sealing discs size A, B and C
– 1 sealing disc support
– 2 single ended spanners of 12 mm A/F
not includet:
- 1 wooden box
– 1 set of collets (11 sizes) covering a
total span of dia. 0.2 to 5.0 mm
Last updated
21.10.2015 08:30